Fancy1002 wrote:MEANINGLESS_NUMBERS wrote:Fancy1002 wrote:What’s g limit?
2.5Gs
Not what’s the G limit, what is G limit, the term?
G-force is a measure of force per unit mass exerted on an object, in terms of standard gravity. For example, if you're standing on the ground, you experience 1.0 G upward, which cancels out the 1G of gravity and allows you to be stationary.
In aviation, it's commonly used to describe the
load factor, which describes the upward force exerted on the aircraft in terms of g-forces. In straight and level flight, you're usually experiencing 1 G. Aircrafts making a turn (banking) usually increases the load factor required to maintain level flight, which is why you, as a passenger, may feel that you're "pushed" into your seat in the process. When the aircraft experiences turbulence, the load factor often fluctuates.
Each aircraft is rated for a maximum load factor, which specifies the maximum force that an aircraft can be subject to. Forces above this certified limit are unsafe, and can result in mechanical failures or even breaking up of the aircraft. Some standard values are listed
here.
With the kind of wild elevation changes that the AF plane experienced in Melissa's eye, the aircraft was almost certainly experiencing intermittent or oscillating load factors higher than it was certified for. An inspection of the aircraft would likely be needed to see if they did any damage.
This is also why it would be a bad idea to go in for a second pass immediately: if the high G-forces already accelerated metal fatigue, the airframe could have already been made more fragile, which would increase the risk of a second pass even if the first pass turned out okay.